RZNC-0501 Users Guide. 4) It begins to setup driver program, click on “Continue Anyway” when it clews “The program does not pass Microsoft. Driver口DC5V output. Don't supply any other voltage to this pin. X axis pulse signal output terminal. Output Vol≧3V Current≦8mA. X axis direction.
Posted by2 years ago
Archived
3040CNC with DSP-0501 control question
Hi all. I've just finished wiring my DSP-0501 hand controller to my 3040, and it's very nice so far, although I've hit something of an issue - I can't seem to successfully switch from C-axis control back to Y-axis control. The shortcut that's listed in the manual (and I use the word manual very loosely) is ON/OFF&Z-/Z+ - however, whichever combination of those I use, I get the message 'Switch grade 1', and the C axis remains active over the Y axis. Short of unplugging the C axis from the DSP board (which I'd rather not have to resort to), is there anything that I can do to resolve this?
86% Upvoted